Newer
Older
.. _pynq-z2-setup:
*******************
PYNQ-Z2 Setup Guide
*******************
Prerequisites
=============
* PYNQ-Z2 board
* Computer with compatible browser (`Supported Browsers
<http://jupyter-notebook.readthedocs.org/en/latest/notebook.html#browser-compatibility>`_)
* Ethernet cable
* Micro USB cable
* Micro-SD card with preloaded image, or blank card (Minimum 8GB recommended)
Getting Started Video
=====================
You can watch the getting started video guide, or follow the instructions in
:ref:`pynqz2-board-setup`.
.. raw:: html
<embed>
<iframe width="560" height="315" src="https://www.youtube.com/embed/RiFbRf6gaK4" frameborder="0" allowfullscreen></iframe>
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
.. _pynqz2-board-setup:
Board Setup
===========
.. image:: ../images/pynqz2_setup.png
:align: center
1. Set the ** Boot** jumper to the *SD* position.
(This sets the board to boot from the Micro-SD card)
2. To power the board from the micro USB cable, set the **Power**
jumper to the *USB* position. (You can also power the board from an external 12V
power regulator by setting the jumper to *REG*.)
3. Insert the Micro SD card loaded with the PYNQ-Z2 image into the **Micro
SD** card slot underneath the board
4. Connect the USB cable to your PC/Laptop, and to the **PROG - UART**
MicroUSB port on the board
5. Connect the Ethernet port by following the instructions below
6. Turn on the PYNQ-Z2 and check the boot sequence by following the instructions below
.. _turning-on-the-PYNQ-Z2:
Turning On the PYNQ-Z2
----------------------
As indicated in step 6 of :ref:`pynqz2-board-setup`, slide the power switch to the *ON*
position to turn on the board. The **Red** LED will come on immediately to
confirm that the board has power. After a few seconds, the **Yellow/Green
/ Done** LED will light up to show that the Zynq® device is operational.
After a minute you should see two **Blue ** LEDs and four
**Yellow/Green** LEDs flash simultaneously. The **Blue** LEDs
will then turn on and off while the **Yellow/Green** LEDs remain on. The
system is now booted and ready for use.
.. include:: network_connection.rst